| Headlamps
and horn switch |
Fig.
22 or 24 |
| Off: |
The lights are off when the side of the
knob (9) marked "O" is facing the driver. |
| Side and tail lamps: |
Turn the knob one notch ("V").
If the dashboard does not light up, check that the side and tail
lamps are on.
If they are not, replace the corresponding fuse (see page 34). |
| Main beam: |
Turn the knob to the second notch ("R"). |
| Dipped beam: |
From "side and tail lamps on"
or "Main beam" positions, push the lever away from the
steering wheel. |
| Horn: |
Press the end of knob (9). |
| On: |
With the dipped beam on, actuate switch
(6). The yellow warning lamp (5) should come on. |
| Off: |
Actuate switch (6) again; the warning
lamp should go out. |
| Hazard
warning switch |
Fig.
22 or 24 |
| To operate: |
Turn button (3) one quarter of a turn to
the right or to the left, the four warning lamps will flash
simultaneously.
The corresponding red warning lamp (4) should flash on the
dashboard throughout the operation. |
| To cancel: |
Turn button again, the arrow must be
vertically positioned.
The red warning lamp should go out immediately. |
| To operate: |
Press button (3): the four direction
indicators will flash simultaneously. A red warning lamp (4) should
flash on the dashboard throughout the operation. |
| To cancel: |
Push the button again.
The red warning lamp should go out immediately. |
|
Fig. 23
Fig. 24 - Signal and
lighting controls
1 - Direction indicator, R.H. side
2 - Direction indicator, L.H. side
3 - Hazard warning switch
4 - Hazard warning indicator lamp
7 - Windscreen wiper
8 - Windscreen washer
9 - Lighting and horn control
|
